fivensa.blogg.se - Staples one touch stapler instruction manual

SAFETY INSTRUCTIONS CONTINUED CLINCH ADJUSTMENT If you are using 3/4″ staples set L up.ī. Adjust L/S screw with a screwdriver to the desired setting.Loosen the set screw on the bottom with a 3mm Allen wrench.Swing cover closed and squeeze to snap closed.Push forward until stopping in driver guide unit. Feed front end of coil staples into right coil guide, left coil guide and top guide. Slightly squeeze the cover back, then pull the top cover open.SAFETY INSTRUCTIONS CONTINUED LOADING THE STAPLER Check the filter and drain on a daily basis. Check oil level in the oiler daily.Ī filter is recommended on your air compressor.

NOTE: The following illustration shows the correct mode of connection to the air supply system which will increase the efficiency and life of the stapler.Many air tool users find it convenient to use an inline oiler to provide oil circulation through their tool. If inline oiler is used, manual lubrication through the air inlet is not required on a daily basis.

Wipe off excessive oil at the exhaust.

Operate the tool briefly after adding oil.

Turn the stapler so that the inlet is facing up and put one drop of high-speed spindle oil, UNOCOL RX22, or 3-in-1 oil into air inlet.

Disconnect the stapler from the air supply prior to servicing.

Lubricate the stapler prior to initial operation.

Never point the stapler at yourself or anyone else.

Do not place your hand or any other body part in the staple clinching area or adjustment window when connecting or disconnecting the air supply.

Do not use a check valve or any other fitting which allows air to remain in the stapler.

safety glasses, hearing protection and head protection.

Never carry the stapler by the hose or pull on the hose to move the stapler.

Do not pull the trigger when carrying or holding the stapler.

Disconnect the stapler from the air supply before making adjustments, cleaning or clearing jams and when not in use.

Do not exceed 110psi of air pressure when operating the stapler.

Vapors left on the stapler could ignite and cause the tool to explode.4.

Never use gasoline or other flammable liquids to clean the stapler.

Never use flammable gases as a power source for the stapler.

If you have questions, contact Uline at 1-80. Read the manual and understand all safety instructions before operating the tool.